01

Type

Dynamic speaker

02

Dimension

External diameter2515 mm

03

Rated Input Power

1.0 W

04

Impedance

8 ohm±15% at1KHz

05

Resonance Frequency (Fo)

600 Hz±20% at  Fo, 1V

06

Sensitivity (S.P.L.)

92dB(1W/1m)±3 dB

at AVE 0.4K,0.6K,0.8K 1.0K(Hz).

07

Frequency Range

Fo–20KHz

08

Distortion

Less than 10 % at 2000Hz2.0W

09

Max. Input Power

Must be normal at1.5W white noise for 1 minute.

10

Voice Coil

Diameter8.7 mm

11

Magnet

Rare earth permanent (Nd-Fe-B) magnetΦ8.0 x 2.0mm

12

Weight

3.2g±0.2g

13

Appearance

Should not exist any obstacle to be harmful to normal operation; damages, cracks, rusts and distortions, etc.

14

Operation Test

Must be normal at program source1.0W

15

Buzz, Rattle, etc.

Should not be audible at2.83V sine Wave between Fo to 20KHz

16

Polarity

When positive voltage is applied to the terminal marked (+), diaphragm should move to the front.

17

Terminal Strength

Capable of withstand 1kg load for 30 seconds without resulting in any damage or rejection.

18

Load Test

1.0W white noise is applied for 96 hours and satisfy the test listed on item 05,06,13,15

19

High Temp. Test

Keep 96 hours at +70℃±3℃ and leave 3 hours in normal temperature and then check

20

Low Temp. Test

Keep 96 hours at -20℃±3℃ and leave 3 hours in normal temperature and then check

21

Humidity Test

Keep 96 hours at + 60℃±3℃ relative humidity 95% and leave 3 hours in normal temperature and then checked.

22

Drop Test

Drop the speakers contained in normal box onto the board 20mm thick 10 times from the height of 0.75m and then should satisfy the test listed on item 13 and 15

Measurement Condition

Test and measurement will be carried out under normal condition of temperature

within 5℃to 35℃,relative humidity within 45% to 85% and air pressure of 860mbar to 1060mbar.

Should uncertainly arise in data obtained from the above atmosphere, control of temperature

At 20℃±2℃ and relative humidity within 60% and 70%, with air pressure remaining unchanged, To be enforced.

1.Microphone : B&K 4191

2.Standard Baffle :In IEC 268-5 Where 1350mm x 1650mm

3.Testing Distance : 0.1m

4.Zero Level : -dB

5.Mode : SPEAKER

6.Input Power :1.0W

7.potentiometer Range : 50dB

8.Sweep Time : 0.5sec

Frequency Response Curve